ProRoute router guide

ProRoute H685 Ping Reboot (Cell ICMP Check) Guide

How to set up Cell ICMP Check, the ProRoute H685 and H820 ping reboot feature: hosts, reconnect and the right action when the check fails.

ModelH685 Category4G Network4G LevelBeginner

I launched the ProRoute H685 and H820 4G routers in 2013, and Cell ICMP Check was the feature I talked about more than any other. It is ProRoute’s name for ping reboot. On the H685 it is a few ticks and two addresses, which was the whole point: make the most important recovery feature on a remote router the easiest one to switch on.

Cell ICMP Check at a glance

RoutersProRoute H685 and H820 (3G, 4G and 5G versions)
WhereInternet Settings, Cell ICMP Check
HostsHost1 and Host2
ActionsRestart module or Restart router
Original defaultsGoogle Public DNS, 8.8.8.8 and 8.8.4.4
Biggest trapUsing public hosts on a private APN SIM

What Cell ICMP Check does

The router pings the hosts you give it. If they stop answering, it assumes the mobile network has dropped the data session, even if the modem still looks registered, and it recovers the connection itself. It exists because, as I used to tell every CCTV installer, mobile data is not an always-on connection. It is an always-available one, and the network will drop you sooner or later.

Setting it up

  1. Get connected first. Set the APN and confirm the router has a working connection before you enable the check.
  2. Open Internet Settings, then Cell ICMP Check.
  3. Tick Enable.
  4. Set Host1 and Host2. The routers came with Google’s DNS addresses, 8.8.8.8 and 8.8.4.4. On an internet SIM I now prefer two different operators, for example 8.8.8.8 and 9.9.9.9, so one company’s outage cannot trigger a restart. On a private APN, use addresses inside the APN.
  5. Tick Reconnect, so the router re-establishes the connection when the check fails.
  6. Set Action when failed to Restart module. That restarts the radio module, the modem, without rebooting the whole router. Use Restart router only if module restarts do not clear the fault.
  7. Apply.

With hindsight, 8.8.8.8 and 8.8.4.4 were two doors into the same building. They were a sensible default in 2013 and they still work, but pairing two different operators is better. I explain the reasoning in which IP address to ping.

Private APN SIMs

A lot of H685s went into CCTV with fixed IP and private APN SIMs. If the APN has no internet breakout, Google’s addresses can never reply, Cell ICMP Check fails every time, and the router restarts its module in a loop. Ask the SIM provider for an address inside the APN that always answers ping, or use the server the cameras report to. Ping Reboot on Private IP SIM Cards covers this properly.

Where it came from

ProRoute did not invent ping reboot. Ping watchdogs were already in network equipment in the mid-2000s. What we did was make it a default habit for UK installers, through the setup guides, the videos and a lot of phone calls. That story is in the history of ping reboot, and the feature itself is explained in Cell ICMP Check.

Questions

Where is Cell ICMP Check on a ProRoute H685?

In the web interface under Internet Settings, Cell ICMP Check. Tick Enable, set Host1 and Host2, tick Reconnect and choose the action.

Should I choose Restart module or Restart router?

Restart module first. It restarts the modem and is quicker. Use Restart router only if module restarts do not clear the fault.

Is Cell ICMP Check the same as ping reboot?

Yes. Cell ICMP Check is ProRoute’s name for ping reboot, the same idea Teltonika calls Ping Reboot and MikroTik calls the ping watchdog.