Ping reboot tools and network diagnostics
Work out safe ping reboot settings, how long a failure lasts, and which address to ping, then check your own connection. Everything runs in your browser.
Ping reboot settings builder
Choose your router and how it connects. You get settings, the menu path and any warnings before you change anything on site.
Recommended settingsSafe
Where to set it
Recovery time and reboot loop calculator
How long a dead link stays dead before ping reboot acts, and what happens if the target can never answer.
If the link stalls
If the target can never answer (cycle of death)
Ping target chooser
Public addresses that are reasonable ping targets for internet-connected routers, with a reachability check from your browser.
Rules for choosing
- Two operators, not two addresses. 8.8.8.8 and 8.8.4.4 are both Google. Pair Google with Quad9 or Cloudflare.
- Act only when both fail. Check how your router combines hosts. Separate rules usually act independently.
- IP addresses, not hostnames. A hostname adds DNS to the test, so a DNS fault looks like a dead link.
- Closed APN? None of these will answer. Ping the APN gateway or your VPN head end.
- Allow retries. Public resolvers rate-limit ICMP, so the odd lost reply is normal.
ICMP data usage calculator
What routine ping checks add to a metered IoT SIM each month.
Per router
Check your own connection
IP, DNS and speed checks that run from this browser, useful when you are on site with a laptop on the router's LAN.
HTTP latency test
Times six HTTPS requests from your browser to a host. Browsers cannot send ICMP, so this is a stand-in for ping.
IP lookup
Network, ASN and approximate location for any public IP address.
DNS lookup
A, AAAA, MX, TXT, CNAME and NS records over DNS over HTTPS.
Reverse DNS
The PTR record (hostname) for an IPv4 address.
Subnet calculator
Network, mask, broadcast and usable range from CIDR notation.
Speed test
Download and upload throughput to Cloudflare's edge. Uses about 11 MB of data.
Port checks
Browsers cannot open raw TCP connections, so an honest port check has to run from a terminal.
nc -vz -w 3 203.0.113.10 443 # Windows PowerShell Test-NetConnection 203.0.113.10 -Port 443
Traceroute
Run it from the router itself where you can. RutOS has it under Network, Diagnostics.
traceroute -n 8.8.8.8 # Windows tracert -d 8.8.8.8
Questions
What is the best IP address to ping for ping reboot?
The one that proves your router can do its job. For an internet SIM, use two public resolvers from different operators, for example 8.8.8.8 and 9.9.9.9. On a closed private APN, use an address inside the private network, such as the APN gateway or your VPN head end.
Why does my router keep rebooting every few minutes?
Usually because the ping target is unreachable by design, for example 8.8.8.8 on a private APN with no internet breakout. The router fails every check and reboots in a loop. Use the settings builder above to pick a reachable target.
How much data does ping reboot use?
Very little. One IPv4 ping with the default 56 byte payload is 84 bytes each way. Pinging one host every 5 minutes is roughly 1.5 MB a month before any operator rounding.
Can a website ping my router?
Browsers cannot send ICMP. The latency and reachability checks on this page time HTTPS requests from your browser instead, which is a useful comparison but not the same as a ping from your router.
What is my IP address?
It is shown at the top of the network tools section. It is the public address your ISP or mobile operator gives you, which on mobile is often shared through carrier-grade NAT.